BituFLAMEŽ  Torch applied waterproofing membrane
bituFLAMEŽ membranes are APP-modified bitumen membrane reinforced with non-woven polyester or fiberglass fabric. The bituFLAMEŽ system may be fully torched, mechanically fixed or cold-applied using a bitumen adhesive depending on the performance required.

bituflame base sheet bituFLAMEŽ BS (Base Sheet) Membrane
A 2mm or 3mm thick 60gram/m2 fibreglass reinforced polymer APP modified bituminous membrane. The top surface is finished with a polythene film. It is designed to be used as a base sheet for double layers systems or as an underflashing.

bituFLAMEŽ BS Mat Membrane
A polypropylene fleece on the underside and a polythene film top surface, normally installed as a base layer in a multi layer torchon system. Designed for application to heat and flame sensitive substrates such as T&G sarking or thermal insulation, it is also suited for use as a base layer on rough or uneven surfaces, or over sound existing membranes such as rubber, PVC, bitumen, acrylic and polyurethane. It can be loose laid, mechanically fastened, adhered with adhesives or laid in hot melt bitumen using the pour and roll method.

 bituflame mineral bituFLAMEŽ T
3mm or 4mm thick APP modified bituminous membrane. bituFLAMEŽ T has been designed for use in single or multilayer systems in horizontal and vertical tanking waterproofing, rooftop garden landscapes and planter box areas.

bituFLAMEŽ CS
A 4.5kg/m2 APP-modified bitumen membrane with a 180gm/m˛ spunbond composite polyester reinforcement. bituFLAMEŽ CS has a thin torch-off polyethylene film on the under side, and polypropylene mat or mineral chip on the top surface. Available in Black, Green and White finish.




bituflame grey mineral SPECIALIST MEMBRANES

bituFLAMEŽ VBS
A 74gram/m2 fibreglass reinforced polymer APP modified bituminous membrane perforated with 119 holes per m2. The sheet is covered with heat sensitive polythene film on both sides and is used as a base layer to allow dispersion of vapour in exposed bitumen sheet waterproofing systems with venting.

Plura R
A specifically designed re-roof membrane compatible with SBS and APP modified bitumen membranes. Its very low viscosity bitumen enable it to be used directly over old granule-finished torch-on membranes.

bituFLAMEŽ Membranes are manufactured in Italy by Pluvitec sPa and marketed in NZ by Sealco Waterproofing Systems Ltd.
BRANZ Appraisal No:404 (2005), Amended 20th December 2007

Technical Specifications 
Technical
Properties
bituflame
BS
bituflame
BS Mat
bituflame
T
bituflame
CS
bituflame
VBS
plura R
Reinforcement
F=Fibreglass
P= Polyester
F
60
g/m2
P
.
g/m2
P
180
g/m2
P
180
g/m2
F
74
g/m2
P
180
g/m2
Thickness
2mm & 3mm
2.0mm
3.0mm
4.5kg/m2
2.0mm
5 kg/m2
Top Surface
Polythene
Polythene
Polythene
Granules
Polythene
Polythene